[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Dvdrtools-users] Help with Sony DRX-500ULX drive
From: |
Volker Kuhlmann |
Subject: |
Re: [Dvdrtools-users] Help with Sony DRX-500ULX drive |
Date: |
Thu, 26 Jun 2003 15:15:19 +1200 |
> did you also try the Sony DRX-500ULX USB2 drive with the OSS DVD extensions
> for cdrtools-2.0 ? :
Patience patience - I'm getting to that ;)
I no longer have access to the drive, but was able to borrow it for a
few hours yesterday.
Firmware upgraded to 2.0 on the drive.
0,0,0 0) 'SONY ' 'DVD RW DRU-500A ' '2.0f' Removable CD-ROM
Connected via ieee1394, the box only has USB1 which works fine with
this drive for everything but writing DVDs. Kernel 2.4.20, SuSE 8.2. I
wanted to know what my options would be for writing DVDs. Due to bad
timing the supply of DVD+RW had run out this week, so I could only test
DVD-RW.
growisofs: complains about "mounted media is not DVD+R(W)". Sorry no
testing this with +RW this time.
I assume cdrecord-ossdvd is identical to dvdrecord, except that it is
based on cdrecord 2. Is this correct Robert? In that case, dvdrecord
should be committed to the attic, and I didn't test it.
With cdrecord-ossdvd, -load, -eject, blank=fast are working fine. -toc
works if the disk has something on it, it gives a scsi error otherwise:
cdrecord-ossdvd: Input/output error. read toc: scsi sendcmd: no error
CDB: 43 00 00 00 00 00 00 00 04 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 70 00 05 19 44 4A 93 0A 00 00 00 00 24 00 00 00
Sense Key: 0x5 Illegal Request, Segment 0
Sense Code: 0x24 Qual 0x00 (invalid field in cdb) Fru 0x0
Sense flags: Blk 423905939 (not valid)
cmd finished after 0.004s timeout 40s
cdrecord-ossdvd: Cannot read TOC header
cdrecord-ossdvd: Cannot read TOC/PMA
In some (all?) cases cdrecord-prodvd gives a scsi error too for -toc on
a blank disk.
There are other downsides to cdrecord-ossdvd. -atip doesn't ever seem
to show anything useful. Writing in TAO (i.e. default) mode failed:
Supported modes: PACKET SAO
Drive buf size : 4718592 = 4608 KB
FIFO size : 4194304 = 4096 KB
cdrecord-ossdvd: Drive does not support TAO recording.
cdrecord-ossdvd: Illegal write mode for this drive.
This appears to be nonsense, as cdrecord-prodvd says:
Supported modes: TAO PACKET SAO SAO/R96R RAW/R96R
Drive buf size : 4718592 = 4608 KB
FIFO size : 4194304 = 4096 KB
Track 01: data 3906 MB padsize: 30 KB
Total size: 3906 MB = 2000015 sectors
Current Secsize: 2048
Blocks total: 2298496 Blocks current: 2298496 Blocks remaining: 298481
Starting to write CD/DVD at speed 1 in real TAO mode for single session.
Writing to a blanked DVD-RW fails with:
cdrecord-ossdvd dev=0,0,0 speed=1 -data -dao -v /data/tmp/diskimg
========================================================================
scsidev: '0,0,0'
scsibus: 0 target: 0 lun: 0
Linux sg driver version: 3.1.24
cdrecord-ossdvd: Warning: using inofficial libscg transport code version
(address@hidden '@(#)scsi-linux-sg.c 1.75 02/10/21 Copyright 1997 J.
Schilling').
Cdrecord 2.0 (i686-suse-linux) Copyright (C) 1995-2002 Jörg Schilling
TOC Type: 1 = CD-ROM
Using libscg version 'schily-0.7'
atapi: 1
Device type : Removable CD-ROM
Version : 2
Response Format: 2
Capabilities :
Vendor_info : 'SONY '
Identifikation : 'DVD RW DRU-500A '
Revision : '2.0f'
Device seems to be: Generic mmc2 DVD-R/DVD-RW.
Using generic SCSI-3/mmc DVD-R(W) driver (mmc_mdvd).
Driver flags : SWABAUDIO BURNFREE
Supported modes: PACKET SAO
Drive buf size : 4718592 = 4608 KB
FIFO size : 4194304 = 4096 KB
Track 01: data 3906 MB
Total size: 4486 MB (444:26.66) = 2000000 sectors
Lout start: 4486 MB (444:28/50) = 2000000 sectors
Current Secsize: 2048
ATIP start of lead in: -150 (00:00/00)
Disk type: unknown dye (reserved id code)
Manuf. index: -1
Manufacturer: unknown (not in table)
Blocks total: 2298496 Blocks current: 2298496 Blocks remaining: 298496
Starting to write CD/DVD at speed 1 in real SAO mode for single session.
Last chance to quit, starting real write in 9 seconds. 8
seconds. 7 seconds. 6 seconds. 5
seconds. 4 seconds. 3 seconds. 2
seconds. 1 seconds. 0 seconds. Operation starts.
Waiting for reader process to fill input buffer ... input buffer ready.
BURN-Free is ON.
Performing OPC...
Sending CUE sheet...
Starting new track at sector: 2000166
Track 01: 0 of 3906 MB written.cdrecord-ossdvd: Input/output error.
write_g1: scsi sendcmd: no error
CDB: 2A 00 00 1E 85 26 00 00 1F 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 70 00 05 19 44 4A 93 0A 00 00 00 00 2C 00 00 00
Sense Key: 0x5 Illegal Request, Segment 0
Sense Code: 0x2C Qual 0x00 (command sequence error) Fru 0x0
Sense flags: Blk 423905939 (not valid)
cmd finished after 0.003s timeout 200s
Sense Bytes: 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
write track data: error after 0 bytes
I used the binary I compiled myself, starting with the SuSE cdrecord
(patched) source and adding Robert's dvd patch.
Unfortunately, I have to conclude the cdrecord-prodvd seems to be the
only program which can currently be relied upon, although the problem in
-ossdvd seems fixable. There doesn't seem to be much going on with Linux
and dvd development atm though.
Volker
--
Volker Kuhlmann is possibly list0570 with the domain in header
http://volker.dnsalias.net/ Please do not CC list postings to me.
Re: [Dvdrtools-users] Help with Sony DRX-500ULX drive, Robert M. Stockmann, 2003/06/22
Re: [Dvdrtools-users] Help with Sony DRX-500ULX drive, Robert M. Stockmann, 2003/06/24