[Dvdrtools-users] Pioneer A03 problems

[Peter J. Braam]

Hi, 

I issued the following command: 

mkisofs -R /home/braam | dvdrecord -v fs=8m speed=2 -dao dev=0,0,0 -

The following error occurred. 

Any ideas about what I should be doing to get this guy going? 

Thanks!

- Peter -

... stuff from mkisofs ...
2.4.0-test12.ext2snap-0.06.patch (linux-2.4.0-test12.coresnap-0.06.patch)
Using generic SCSI-3/mmc DVD-R(W) driver (mmc_mdvd).
Driver flags   : SWABAUDIO 
Supported modes: PACKET SAO
Drive buf size : 1245184 = 1216 KB
FIFO size      : 8388608 = 8192 KB
Track 01: data  unknown length
Total size:       0 MB (00:00.00) = 0 sectors
Lout start:       0 MB (00:02/00) = 0 sectors
Current Secsize: 2048
  ATIP start of lead in:  -150 (00:00/00)
Disk type:    unknown
Manuf. index: -1
Manufacturer: unknown (not in table)
dvdrecord: WARNING: Total disk size unknown. Data may not fit on disk.
Starting to write CD/DVD at speed 2 in write mode for single session.
Last chance to quit, starting real write in 0 seconds. Operation starts.
Waiting for reader process to fill input buffer ... input buffer ready.
trackno=0
Performing OPC...
Sending CUE sheet...
dvdrecord: WARNING: Drive returns wrong startsec (0) using -150
Starting new track at sector: 0
Track 01:   0 MB written.dvdrecord: Input/output error. write_g1: scsi sendcmd: 
no error
CDB:  2A 00 00 00 00 1F 00 00 1F 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 70 00 05 00 00 00 00 0E 00 00 00 00 21 02 00 00
Sense Key: 0x5 Illegal Request, Segment 0
Sense Code: 0x21 Qual 0x02 (logical block address out of range) [No matching qua
lifier] Fru 0x0
Sense flags: Blk 0 (not valid) 
cmd finished after 0.006s timeout 200s

write track data: error after 63488 bytes
Sense Bytes: 70 00 00 00 00 00 00 0E 00 00 00 00 00 00 00 00 00 00
Writing  time:   10.050s
Fixating...
Fixating time:   73.490s
dvdrecord: fifo had 129 puts and 2 gets.
dvdrecord: fifo was 0 times empty and 1 times full, min fill was 99%.



- Peter -