[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Discuss-gnuradio] Power,Bandwidth and sp ectrum switch problems
From: |
Marcus D. Leech |
Subject: |
Re: [Discuss-gnuradio] Power,Bandwidth and sp ectrum switch problems |
Date: |
Wed, 30 Jun 2010 20:41:00 -0400 |
User-agent: |
Mozilla/5.0 (X11; U; Linux i686; en-US; rv:1.9.1.9) Gecko/20100430 Fedora/3.0.4-2.fc12 Thunderbird/3.0.4 |
On 06/30/2010 08:05 PM, Eric Blossom wrote:
> On Tue, Jun 29, 2010 at 11:23:36PM -0700, Johnson_lu wrote:
>
>> Hi guys,
>> Could anybody can help me for these problems?
>> 1、I varied Tx_amplitude from 0.1 to 1 and measured the output with a
>> spectrum analyzer. But the changes are very little. The output is almost the
>> same when Tx_amplitude is 0.1 and 1. How can I reduce the transmit power to
>> a very little value?
>>
All else being equal that should produce a 10dB change in signal power,
unless *something* in the
chain is already at saturation due to other factors in the Tx chain.
Keep in mind that a 10dB change
on a logarithmic scale isn't very much.
>> 2、How do I know bandwidth of transmission and reception channels in
>> tunnel.py?
>>
There seem to be *two* versions of tunnel.py in the examples--which one
are you talking about?
Have you put the output of the transmit side on a spectrum analyser?
That would tell you
unambiguously what the bandwidth is, but also careful and
knowledgeable inspection of the
code will tell you what the theoretical bandwidth is.
--
Marcus Leech
Principal Investigator
Shirleys Bay Radio Astronomy Consortium
http://www.sbrac.org