[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Discuss-gnuradio] Power,Bandwidth and spectru m switch problems
From: |
An He |
Subject: |
Re: [Discuss-gnuradio] Power,Bandwidth and spectru m switch problems |
Date: |
Wed, 30 Jun 2010 09:59:31 -0400 |
1. Change tx-gain if you are using tunnel.py. The default value is set to the mid value. Use -h to find out more.
2. Spectrum analyzer would help you to observe. I believe you can also "calculate" based on your settings. Maybe someone can point out where in the code the bandwidth relationship is determined.
3. Not sure why. I thought someone had implemented a FH system.
An
On Wed, Jun 30, 2010 at 2:23 AM, Johnson_lu
<address@hidden> wrote:
Hi guys,
Could anybody can help me for these problems?
1、I varied Tx_amplitude from 0.1 to 1 and measured the output with a
spectrum analyzer. But the changes are very little. The output is almost the
same when Tx_amplitude is 0.1 and 1. How can I reduce the transmit power to
a very little value?
2、How do I know bandwidth of transmission and reception channels in
tunnel.py?
3、I am using an USRP2 with Gnu Radio and XCVR2450 as daughterboard. I want
to switch frequency among different channels 2.4G~2.5G. However, I find that
switch only can succeed about 20 times, then fails.
The python code is:
self.tb.lock()
ok = self.tb.txpath.set_freq(new_freq)
if not ok:
print "Failed to set Tx frequency"
raise SystemExit
ok = self.tb.rxpath.set_freq(new_freq)
if not ok:
print "Failed to set Rx frequency"
raise SystemExit
self.tb.unlock()
--
View this message in context: http://old.nabble.com/Power%EF%BC%8CBandwidth-and-spectrum-switch-problems-tp29031239p29031239.html
Sent from the GnuRadio mailing list archive at Nabble.com.
_______________________________________________
Discuss-gnuradio mailing list
address@hidden
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio