[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Discuss-gnuradio] Beagleboard
From: |
Philip Balister |
Subject: |
Re: [Discuss-gnuradio] Beagleboard |
Date: |
Tue, 5 Aug 2008 09:58:31 -0400 |
On Sun, Aug 3, 2008 at 3:32 PM, Eric A. Cottrell <address@hidden> wrote:
> Philip Balister wrote:
>>
>> On Fri, Aug 1, 2008 at 6:31 PM, Eric Brombaugh <address@hidden>
>> wrote:
>>
>>>
>>> On Aug 1, 2008, at 1:58 PM, Philip Balister wrote:
>>>
>>>>
>>>> I've been talking to a friend (he knows FPGA stuff much better than
>>>> me) about using the expansion port to communicate with an FPGA via a
>>>> SDIO interface. I don't think we can beat the current USRP data rate,
>>>> but we should be able to reduce the latency introduced by the USB
>>>> interface.
>>>>
>>>
>>> Looks like the SDIO ports run up to 50MHz and have 8-bit wide data. No
>>> idea
>>> how much overhead there is in that, but it might be able to go a bit
>>> faster
>>> than USB2.0 and as you note would have a lot less latency. Hook up to a
>>> decent FPGA and you could cram a bit of external pre-processing in as
>>> well.
>>> I picked up one of the Avnet Xilinx Spartan 3A boards for $50 that would
>>> probably work well for that.
>>>
>>
>> We are hoping to create a board with a reasonable FPGA that works with
>> existing USRP daughterboards. This would make a really neat system for
>> small SDR nodes. I'll be sure to keep you updated on out progress.
>>
>> Using an existing dev board for developing the beagle to FPGA
>> interface is a really good idea, thanks for suggesting it!
>>
>> Philip
>>
>
> Hello,
>
> Since I have some receive only applications I would like to see a box that
> took one RX or a RX/TX set of USRP daughterboard(s).
>
> The OMAP has some interesting interfaces and I wonder if some of them could
> be adapted for a more general I/O use. I am more familiar with the earlier
> versions of the OMAP. It will be nice to use the DSP for some signal blocks
> and use the ARM for more general UI and I/O blocks.
We made a list to discuss our Beagle/FPGA project. You can subscribe
by sending an email to address@hidden We are
definitively open to ideas and suggestions.
Philip
- [Discuss-gnuradio] Beagleboard, Eric Cottrell, 2008/08/01
- Re: [Discuss-gnuradio] Beagleboard, Philip Balister, 2008/08/01
- Re: [Discuss-gnuradio] Beagleboard, Eric Brombaugh, 2008/08/01
- Re: [Discuss-gnuradio] Beagleboard, Philip Balister, 2008/08/01
- Re: [Discuss-gnuradio] Beagleboard, Eric Brombaugh, 2008/08/01
- Re: [Discuss-gnuradio] Beagleboard, Philip Balister, 2008/08/02
- Re: [Discuss-gnuradio] Beagleboard, Eric A. Cottrell, 2008/08/03
- Re: [Discuss-gnuradio] Beagleboard, Nikhil Adnani, 2008/08/04
- Re: [Discuss-gnuradio] Beagleboard,
Philip Balister <=