[PULL 33/36] migration: Enable UFFD_FEATURE_THREAD_ID even without blocktime feat

[Juan Quintela]

From: Peter Xu <peterx@redhat.com>

This patch allows us to read the tid even without blocktime feature enabled.
It's useful when tracing postcopy fault thread on faulted pages to show thread
id too with the address.

Remove the comments - they're merely not helpful at all.

Signed-off-by: Peter Xu <peterx@redhat.com>
Reviewed-by: Dr. David Alan Gilbert <dgilbert@redhat.com>
Reviewed-by: Juan Quintela <quintela@redhat.com>
Signed-off-by: Juan Quintela <quintela@redhat.com>
---
 migration/postcopy-ram.c | 14 ++++++--------
 1 file changed, 6 insertions(+), 8 deletions(-)

diff --git a/migration/postcopy-ram.c b/migration/postcopy-ram.c
index d18b5d05b2..2176ed68a5 100644
--- a/migration/postcopy-ram.c
+++ b/migration/postcopy-ram.c
@@ -283,15 +283,13 @@ static bool ufd_check_and_apply(int ufd, 
MigrationIncomingState *mis)
     }
 
 #ifdef UFFD_FEATURE_THREAD_ID
-    if (migrate_postcopy_blocktime() && mis &&
-        UFFD_FEATURE_THREAD_ID & supported_features) {
-        /* kernel supports that feature */
-        /* don't create blocktime_context if it exists */
-        if (!mis->blocktime_ctx) {
-            mis->blocktime_ctx = blocktime_context_new();
-        }
-
+    if (UFFD_FEATURE_THREAD_ID & supported_features) {
         asked_features |= UFFD_FEATURE_THREAD_ID;
+        if (migrate_postcopy_blocktime()) {
+            if (!mis->blocktime_ctx) {
+                mis->blocktime_ctx = blocktime_context_new();
+            }
+        }
     }
 #endif
 
-- 
2.34.1