[PATCH 05/14] hw/intc/arm_gicv3_its: Don't clear GITS_CWRITER on writes to GITS_CBASER

[Peter Maydell]

The ITS specification says that when the guest writes to GITS_CBASER
this causes GITS_CREADR to be cleared.  However it does not have an
equivalent clause for GITS_CWRITER.  (This is because GITS_CREADR is
read-only, but GITS_CWRITER is writable and the guest can initialize
it.) Remove the code that clears GITS_CWRITER on GITS_CBASER writes.

Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
---
 hw/intc/arm_gicv3_its.c | 3 ---
 1 file changed, 3 deletions(-)

diff --git a/hw/intc/arm_gicv3_its.c b/hw/intc/arm_gicv3_its.c
index 1763ba4a671..d9ff7b88492 100644
--- a/hw/intc/arm_gicv3_its.c
+++ b/hw/intc/arm_gicv3_its.c
@@ -866,7 +866,6 @@ static bool its_writel(GICv3ITSState *s, hwaddr offset,
         if (!(s->ctlr & R_GITS_CTLR_ENABLED_MASK)) {
             s->cbaser = deposit64(s->cbaser, 0, 32, value);
             s->creadr = 0;
-            s->cwriter = s->creadr;
         }
         break;
     case GITS_CBASER + 4:
@@ -877,7 +876,6 @@ static bool its_writel(GICv3ITSState *s, hwaddr offset,
         if (!(s->ctlr & R_GITS_CTLR_ENABLED_MASK)) {
             s->cbaser = deposit64(s->cbaser, 32, 32, value);
             s->creadr = 0;
-            s->cwriter = s->creadr;
         }
         break;
     case GITS_CWRITER:
@@ -1027,7 +1025,6 @@ static bool its_writell(GICv3ITSState *s, hwaddr offset,
         if (!(s->ctlr & R_GITS_CTLR_ENABLED_MASK)) {
             s->cbaser = value;
             s->creadr = 0;
-            s->cwriter = s->creadr;
         }
         break;
     case GITS_CWRITER:
-- 
2.25.1