qemu-arm
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[PATCH] target/arm: Use correct entrypoint for SVC taken from Hyp to Hyp


From: Peter Maydell
Subject: [PATCH] target/arm: Use correct entrypoint for SVC taken from Hyp to Hyp
Date: Mon, 17 Jan 2022 13:19:53 +0000

The exception caused by an SVC instruction may be taken to AArch32
Hyp mode for two reasons:
 * HCR.TGE indicates that exceptions from EL0 should trap to EL2
 * we were already in Hyp mode

The entrypoint in the vector table to be used differs in these two
cases: for an exception routed to Hyp mode from EL0, we enter at the
common 0x14 "hyp trap" entrypoint.  For SVC from Hyp mode to Hyp
mode, we enter at the 0x08 (svc/hvc trap) entrypoint.
In the v8A Arm ARM pseudocode this is done in AArch32.TakeSVCException.

QEMU incorrectly routed both of these exceptions to the 0x14
entrypoint.  Correct the entrypoint for SVC from Hyp to Hyp by making
use of the existing logic which handles "normal entrypoint for
Hyp-to-Hyp, otherwise 0x14" for traps like UNDEF and data/prefetch
aborts (reproduced here since it's outside the visible context
in the diff for this commit):

    if (arm_current_el(env) != 2 && addr < 0x14) {
        addr = 0x14;
    }

Signed-off-by: Peter Maydell <peter.maydell@linaro.org>
---
 target/arm/helper.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/target/arm/helper.c b/target/arm/helper.c
index cfca0f5ba6d..a898e400f6c 100644
--- a/target/arm/helper.c
+++ b/target/arm/helper.c
@@ -9655,7 +9655,7 @@ static void arm_cpu_do_interrupt_aarch32_hyp(CPUState *cs)
      * separately here.
      *
      * The vector table entry used is always the 0x14 Hyp mode entry point,
-     * unless this is an UNDEF/HVC/abort taken from Hyp to Hyp.
+     * unless this is an UNDEF/SVC/HVC/abort taken from Hyp to Hyp.
      * The offset applied to the preferred return address is always zero
      * (see DDI0487C.a section G1.12.3).
      * PSTATE A/I/F masks are set based only on the SCR.EA/IRQ/FIQ values.
@@ -9669,7 +9669,7 @@ static void arm_cpu_do_interrupt_aarch32_hyp(CPUState *cs)
         addr = 0x04;
         break;
     case EXCP_SWI:
-        addr = 0x14;
+        addr = 0x08;
         break;
     case EXCP_BKPT:
         /* Fall through to prefetch abort.  */
-- 
2.25.1




reply via email to

[Prev in Thread] Current Thread [Next in Thread]