on 8/28/06 10:27 PM, frank wang at
address@hidden wrote:
Hi,
After I rebuild octave 2.9.7 and octave 2.9.8, I still could not load a simple text file as the one attached. Since I have the source code, I want to debug the code and find out why. Could someone tell me how to debug octave using gdb? how to setup a breakpoint? To debug the load problem, where should I set the breakpoint?
I repeat my problem here again. After type the load test2.txt, octave does not show any data. If I type test2, octave will state that it does not exist. I have tried all suggestions from previous post, but I still cannot solve this.
Thanks
Frank
Frank,
What happens if you type in octave
a=load test2.txt
a
The variable a should have the values from the input file, so entering "a" without ; at the end of the line should print the values.
Joe