[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Trouble installing hurd-F3-main
From: |
Ognyan Kulev |
Subject: |
Re: Trouble installing hurd-F3-main |
Date: |
Sun, 12 Aug 2001 17:19:33 +0300 |
User-agent: |
Mutt/1.2.5i |
On Sun, Aug 12, 2001 at 06:35:58PM +1000, Dave McDonald wrote:
> Hi,
>
> I have downloaded the hurd-F3-mail CD and used it to create installation
> floppies.
>
> The floppies seem to install fine and the Grub boot floppy loads the
> images from the /boot directory on the hard disk, but the boot stops
> (without any error messages) after noting that 419 microcode
> instructions have been loaded into the the Adaptec 2940U card.
This is exactly the problem i had with the same Adaptec card. You must
cross compile GNU Mach under Linux and use it instead of the default in
/boot. See [1], and --aic7xxx option to configure is your case.
[1] http://mail.gnu.org/pipermail/help-hurd/2001-April/004550.html
Regards
--
Ognyan Kulev <ogi@fmi.uni-sofia.bg>, "\"Programmer\""