[PATCH v3 11/15] tests: Allow turning on shell tracing from environment variables

[Glenn Washburn]

This allows turning on shell tracing when its not practical or not possible
to use commandline arguments. Turn on tracing when the envvar is an integer
greater than 1, since these can log a lot of messages.

Signed-off-by: Glenn Washburn <development@efficientek.com>
---
 tests/util/grub-fs-tester.in | 2 ++
 tests/util/grub-shell.in     | 5 ++++-
 2 files changed, 6 insertions(+), 1 deletion(-)

diff --git a/tests/util/grub-fs-tester.in b/tests/util/grub-fs-tester.in
index 2dcd09f5e..6b8028f9b 100644
--- a/tests/util/grub-fs-tester.in
+++ b/tests/util/grub-fs-tester.in
@@ -2,6 +2,8 @@
 
 set -e
 
+[ "${GRUB_TEST_DEFAULT_DEBUG:-0}" -gt 1 ] && set -x
+
 fs="$1"
 
 GRUBFSTEST="@builddir@/grub-fstest"
diff --git a/tests/util/grub-shell.in b/tests/util/grub-shell.in
index fdabc6171..a1c7b9265 100644
--- a/tests/util/grub-shell.in
+++ b/tests/util/grub-shell.in
@@ -215,6 +215,7 @@ esac
 
 timeout=${GRUB_SHELL_DEFAULT_TIMEOUT:-60}
 mkimage_extra_arg=
+debug=${GRUB_SHELL_DEFAULT_DEBUG:-$GRUB_TEST_DEFAULT_DEBUG}
 
 # Check the arguments.
 for option in "$@"; do
@@ -234,7 +235,7 @@ for option in "$@"; do
     --no-trim)
        trim=0 ;;
     --debug)
-        debug=1 ;;
+        debug=$((debug+1)) ;;
     --modules=*)
        ms=`echo "$option" | sed -e 's/--modules=//' -e 's/,/ /g'`
        modules="$modules $ms" ;;
@@ -319,6 +320,8 @@ for option in "$@"; do
     esac
 done
 
+[ "${debug:-0}" -gt 1 ] && set -x
+
 if [ "x${source}" = x ] ; then
     tmpfile="$work_directory/testcase.cfg"
     while read REPLY; do
-- 
2.27.0