[Savannah-register-public] [task #13880] Submission of RFID opendoor for Arduino/Genuino

[Gianmarco]

URL:
  <http://savannah.gnu.org/task/?13880>

                 Summary: Submission of RFID opendoor for Arduino/Genuino
                 Project: Savannah Administration
            Submitted by: garix
            Submitted on: Mon 08 Feb 2016 09:53:17 AM GMT
         Should Start On: Mon 08 Feb 2016 12:00:00 AM GMT
   Should be Finished on: Thu 18 Feb 2016 12:00:00 AM GMT
                Category: Project Approval
                Priority: 5 - Normal
                  Status: None
                 Privacy: Public
        Percent Complete: 0%
             Assigned to: None
             Open/Closed: Open
         Discussion Lock: Any
                  Effort: 0.00

    _______________________________________________________

Details:

A new project has been registered at Savannah 
This project account will remain inactive until a site admin approves or
discards the registration.


= Registration Administration =

While this item will be useful to track the registration process, *approving
or discarding the registration must be done using the specific Group
Administration
<https://savannah.gnu.org/siteadmin/groupedit.php?group_id=11541> page*,
accessible only to site administrators, effectively *logged as site
administrators* (superuser):

* Group Administration
<https://savannah.gnu.org/siteadmin/groupedit.php?group_id=11541>


= Registration Details =

* Name: *RFID opendoor for Arduino/Genuino*
* System Name:  *rfidopendoor*
* Type: non-GNU software and documentation
* License: GNU General Public License v3 or later

----

==== Description: ====
It is a software program written in Arduino language that can be easily
installed on the platforms compatible with the Arduino IDE or ported in other
languages. It permits to open a door when a trusted RFID is detected or when a
signal is sent to the chip (for example with a remote button). 
It is based on the ID-3/ID12/ID20 RFID reader from innovations, but it's
enough to change the reading function if it's used a different reader.
Specific information are in a comment on the source code. There is also an
electronic schematic designed with the free software Fritzing.


==== Tarball URL: ====
http://savannah.gnu.org/submissions_uploads/RFID_opendoor.tar






    _______________________________________________________

Reply to this item at:

  <http://savannah.gnu.org/task/?13880>

_______________________________________________
  Message sent via/by Savannah
  http://savannah.gnu.org/