The NBD spec says that clients should not try to write/trim to
an export advertised as read-only by the server. But we failed
to check that, and would allow the block layer to use NBD with
BDRV_O_RDWR even when the server is read-only, which meant we
were depending on the server sending a proper EPERM failure for
various commands, and also exposes a leaky abstraction: using
qemu-io in read-write mode would succeed on 'w -z 0 0' because
of local short-circuiting logic, but 'w 0 0' would send a
request over the wire (where it then depends on the server, and
fails at least for qemu-nbd but might pass for other NBD
implementations).
With this patch, a client MUST request read-only mode to access
a server that is doing a read-only export, or else it will get
a message like:
can't open device nbd://localhost:10809/foo: request for write access conflicts
with read-only export
It is no longer possible to even attempt writes over the wire
(including the corner case of 0-length writes), because the block
layer enforces the explicit read-only request; this matches the
behavior of qcow2 when backed by a read-only POSIX file.
Fix iotest 147 to comply with the new behavior (since nbd-server-add
defaults to a read-only export, we must tell blockdev-add to set up a
read-only client).
CC: address@hidden
Signed-off-by: Eric Blake <address@hidden>