[PATCH 0/3] ppc: Convert (mostly) from device_legacy_reset() to device_cold_reset()

[Peter Maydell]

The old function device_legacy_reset() (which was originally
device_reset() and got renamed when 3-phase-reset landed) is
deprecated, because it has slightly odd semantics -- it resets the
device itself, but (unlike when a device is reset as part of system
reset) not any qbus it owns (and devices attached to the qbus).  The
replacement is device_cold_reset(), which resets the device and its
bus (if any).

For a device with child bus, the two functions are identical; this
patchset changes the PPC code which uses device_legacy_reset() on
devices which have no qbus to use device_cold_reset() instead; this
should have no functionally visible difference.

There is one other use of device_legacy_reset() in PPC code which I
didn't change: in hw/ppc/spapr_pci.c:spapr_phb_children_reset().  I
couldn't figure out what the children being reset here are and if
they might own buses.  I suspect that even if they do own buses the
right thing would be to change to device_cold_reset(), but I stuck to
only the changes I felt reasonably sure were definitely
no-behaviour-change.

NB: tested with 'make check' and 'make check-acceptance' only.

thanks
-- PMM

Peter Maydell (3):
  hw/intc/spapr_xive: Use device_cold_reset() instead of
    device_legacy_reset()
  hw/ppc/spapr_vio: Reset TCE table object with device_cold_reset()
  hw/ppc/pnv_psi: Use device_cold_reset() instead of
    device_legacy_reset()

 hw/intc/spapr_xive.c | 2 +-
 hw/ppc/pnv_psi.c     | 4 ++--
 hw/ppc/spapr_vio.c   | 2 +-
 3 files changed, 4 insertions(+), 4 deletions(-)

-- 
2.20.1