Re: [Qemu-ppc] [RFC PATCH 09/10] spapr_pci_vfio: Enable DDW

[Alexey Kardashevskiy]

On 08/11/2014 10:02 PM, Alexander Graf wrote:
> 
> On 31.07.14 11:34, Alexey Kardashevskiy wrote:
>> This implements DDW for VFIO. Host kernel support is required for this.
>>
>> Signed-off-by: Alexey Kardashevskiy <address@hidden>
>> ---
>>   hw/ppc/spapr_pci_vfio.c | 75
>> +++++++++++++++++++++++++++++++++++++++++++++++++
>>   1 file changed, 75 insertions(+)
>>
>> diff --git a/hw/ppc/spapr_pci_vfio.c b/hw/ppc/spapr_pci_vfio.c
>> index d3bddf2..dc443e2 100644
>> --- a/hw/ppc/spapr_pci_vfio.c
>> +++ b/hw/ppc/spapr_pci_vfio.c
>> @@ -69,6 +69,77 @@ static void
>> spapr_phb_vfio_finish_realize(sPAPRPHBState *sphb, Error **errp)
>>       /* Register default 32bit DMA window */
>>       memory_region_add_subregion(&sphb->iommu_root, tcet->bus_offset,
>>                                   spapr_tce_get_iommu(tcet));
>> +
>> +    sphb->ddw_supported = !!(info.flags & VFIO_IOMMU_SPAPR_TCE_FLAG_DDW);
>> +}
>> +
>> +static int spapr_pci_vfio_ddw_query(sPAPRPHBState *sphb,
>> +                                    uint32_t *windows_available,
>> +                                    uint32_t *page_size_mask)
>> +{
>> +    sPAPRPHBVFIOState *svphb = SPAPR_PCI_VFIO_HOST_BRIDGE(sphb);
>> +    struct vfio_iommu_spapr_tce_query query = { .argsz = sizeof(query) };
>> +    int ret;
>> +
>> +    ret = vfio_container_ioctl(&sphb->iommu_as, svphb->iommugroupid,
>> +                               VFIO_IOMMU_SPAPR_TCE_QUERY, &query);
>> +    if (ret) {
>> +        return ret;
>> +    }
>> +
>> +    *windows_available = query.windows_available;
>> +    *page_size_mask = query.page_size_mask;
>> +
>> +    return ret;
>> +}
>> +
>> +static int spapr_pci_vfio_ddw_create(sPAPRPHBState *sphb, uint32_t
>> page_shift,
>> +                                     uint32_t window_shift, uint32_t liobn,
>> +                                     sPAPRTCETable **ptcet)
>> +{
>> +    sPAPRPHBVFIOState *svphb = SPAPR_PCI_VFIO_HOST_BRIDGE(sphb);
>> +    struct vfio_iommu_spapr_tce_create create = {
>> +        .argsz = sizeof(create),
>> +        .page_shift = page_shift,
>> +        .window_shift = window_shift,
>> +        .start_addr = 0
>> +    };
>> +    int ret;
>> +
>> +    ret = vfio_container_ioctl(&sphb->iommu_as, svphb->iommugroupid,
>> +                               VFIO_IOMMU_SPAPR_TCE_CREATE, &create);
>> +    if (ret) {
>> +        return ret;
>> +    }
>> +
>> +    *ptcet = spapr_tce_new_table(DEVICE(sphb), liobn, create.start_addr,
>> +                                 page_shift, 1 << (window_shift -
>> page_shift),
> 
> I spot a 1 without ULL again - this time it might work out ok, but please
> just always use ULL when you pass around addresses.

My bad. I keep forgetting this, I'll adjust my own checkpatch.py :)


> 
> Please walk me though the abstraction levels on what each page size
> honoration means. If I use THP, what page size granularity can I use for
> TCE entries?


[RFC PATCH 06/10] spapr_rtas: Add Dynamic DMA windows (DDW) RTAS calls support

+        const struct { int shift; uint32_t mask; } masks[] = {
+            { 12, DDW_PGSIZE_4K },
+            { 16, DDW_PGSIZE_64K },
+            { 24, DDW_PGSIZE_16M },
+            { 25, DDW_PGSIZE_32M },
+            { 26, DDW_PGSIZE_64M },
+            { 27, DDW_PGSIZE_128M },
+            { 28, DDW_PGSIZE_256M },
+            { 34, DDW_PGSIZE_16G },
+        };


Supported page sizes are returned by the host kernel via "query". For 16MB
pages, page shift will return DDW_PGSIZE_4K|DDW_PGSIZE_64K|DDW_PGSIZE_16M.
Or I did not understand the question...



-- 
Alexey