Hello
You are so kind to tell me if there is one method to configure netdev and device parameters to accommodate one network interface generated with following powershell script code.
$loopback_name2 = 'gh3n'
$primary_interface2 = 'Ethernet'
$loopback_ipv4_2 = '192.168.201.1'
$loopback_ipv4_length_2 = '24'
Install-Module -Name LoopbackAdapter -MinimumVersion 1.2.0.0 -Force
Import-Module -Name LoopbackAdapter
New-LoopbackAdapter -Name $loopback_name2 -Force
$interface_loopback2 = Get-NetAdapter -Name $loopback_name2
$interface_main = Get-NetAdapter -Name $primary_interface
Set-NetIPInterface -InterfaceIndex $interface_loopback2.ifIndex -InterfaceMetric "254" -WeakHostReceive Enabled -WeakHostSend Enabled -DHCP Disabled
Set-NetIPInterface -InterfaceIndex $interface_main.ifIndex -WeakHostReceive Enabled -WeakHostSend Enabled
Set-NetIPAddress -InterfaceIndex $interface_loopback2.ifIndex -SkipAsSource $True
New-NetIPAddress -InterfaceAlias $loopback_name2 -IPAddress $loopback_ipv4_2 -PrefixLength $loopback_ipv4_length_2 -AddressFamily ipv4
Disable-NetAdapterBinding -Name $loopback_name2 -ComponentID ms_msclient
Disable-NetAdapterBinding -Name $loopback_name2 -ComponentID ms_pacer
Disable-NetAdapterBinding -Name $loopback_name2 -ComponentID ms_server
Disable-NetAdapterBinding -Name $loopback_name2 -ComponentID ms_lltdio
Disable-NetAdapterBinding -Name $loopback_name2 -ComponentID ms_rspndr
Best regards