Re: [Qemu-discuss] Unable to boot imx6q base sabrelite linux kernel on QEMU.

[Bilal, Muhammad]

sorry, but i'm already using current 3.1 rc2 for this.

________________________________________
From: Peter Maydell <address@hidden>
Sent: Tuesday, November 27, 2018 2:53 PM
To: Bilal, Muhammad
Cc: qemu-discuss
Subject: Re: [Qemu-discuss] Unable to boot imx6q base sabrelite linux kernel on 
QEMU.

On Tue, 27 Nov 2018 at 06:29, Bilal, Muhammad <address@hidden> wrote:

> [   15.631444] mmc0: Timeout waiting for hardware interrupt. retries left=0 
> opcode=34
> [   15.856535] mmc1: Timeout waiting for hardware interrupt. retries left=0 
> opcode=34
> [   15.898265] mmc1: host does not support reading read-only switch, assuming 
> write-enable
> [   15.900140] mmc1: Problem switching card into high-speed mode!
> [   15.906535] mmc1: new SD card at address 4567
> [   15.918145] mmcblk1: mmc1:4567 QEMU! 396 MiB
> [   25.710192] mmc0: Timeout waiting for hardware interrupt. retries left=0 
> opcode=34
> [   35.791966] mmc0: Timeout waiting for hardware interrupt. retries left=0 
> opcode=34
> [   45.872764] mmc0: Timeout waiting for hardware interrupt. retries left=0 
> opcode=34
>
>
>
> Keeps waiting forever here ...

Which QEMU version are you running? We did fix a bug in
the imx mmc controller emulation; the fix for that is in
2.12 or later. Try the current 3.0 rc2 if you aren't already,
just to check if it's something we've fixed.

thanks
-- PMM