Hello,
I am trying to run UEFI on Beagleboard. I have created a image using hwpack_linaro-omap3_20110823-0_armel_supported.tar.gz nano-n-tar-20110823-1.tar.gz, Built UEFI edk2 for beagle board.
In the boot folder of the image I have replaced the u-boot by the UEFI bin.
By running the command
$ qemu-system-arm -M beagle -serial stdio -sd beagle_sd.img -mtdblock \
(WORKROOT)/edk2/Build/BeagleBoard/RELEASE_ARMGCC/FV/BeagleBoard_EFI_flashboot.fd
I am able to boot up the system. However, I cannot use the keyboard interrupt. I also tried adding -device usb-kbd
to the command above but I am not able to use the keyboard.
I am
using Ubuntu-12.04 32bit.Please help regarding this issue.
Regards,
Amit.