qemu-devel
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[PULL 02/65] target/riscv: The whole vector register move instructions d


From: Alistair Francis
Subject: [PULL 02/65] target/riscv: The whole vector register move instructions depend on vsew
Date: Wed, 10 Jan 2024 18:56:30 +1000

From: Max Chou <max.chou@sifive.com>

The RISC-V v spec 16.6 section says that the whole vector register move
instructions operate as if EEW=SEW. So it should depends on the vsew
field of vtype register.

Signed-off-by: Max Chou <max.chou@sifive.com>
Acked-by: Richard Henderson <richard.henderson@linaro.org>
Message-ID: <20231129170400.21251-3-max.chou@sifive.com>
Signed-off-by: Alistair Francis <alistair.francis@wdc.com>
---
 target/riscv/insn_trans/trans_rvv.c.inc | 3 +--
 1 file changed, 1 insertion(+), 2 deletions(-)

diff --git a/target/riscv/insn_trans/trans_rvv.c.inc 
b/target/riscv/insn_trans/trans_rvv.c.inc
index 114ad87397..3871f0ea73 100644
--- a/target/riscv/insn_trans/trans_rvv.c.inc
+++ b/target/riscv/insn_trans/trans_rvv.c.inc
@@ -3643,8 +3643,7 @@ static bool trans_##NAME(DisasContext *s, arg_##NAME * a) 
              \
         QEMU_IS_ALIGNED(a->rs2, LEN)) {                                 \
         uint32_t maxsz = (s->cfg_ptr->vlen >> 3) * LEN;                 \
         if (s->vstart_eq_zero) {                                        \
-            /* EEW = 8 */                                               \
-            tcg_gen_gvec_mov(MO_8, vreg_ofs(s, a->rd),                  \
+            tcg_gen_gvec_mov(s->sew, vreg_ofs(s, a->rd),                \
                              vreg_ofs(s, a->rs2), maxsz, maxsz);        \
             mark_vs_dirty(s);                                           \
         } else {                                                        \
-- 
2.43.0




reply via email to

[Prev in Thread] Current Thread [Next in Thread]