[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[PATCH] hw/sd: Add SDHC support for SD card SPI-mode
From: |
frank . chang |
Subject: |
[PATCH] hw/sd: Add SDHC support for SD card SPI-mode |
Date: |
Tue, 28 Dec 2021 09:50:41 +0800 |
From: Frank Chang <frank.chang@sifive.com>
In SPI-mode, SD card's OCR register: Card Capacity Status (CCS) bit
is not set to 1 correclty when the assigned SD image size is larger
than 2GB (SDHC). This will cause the SD card to be indentified as SDSC
incorrectly. CCS bit should be set to 1 if we are using SDHC.
Also, as there's no power up emulation in SPI-mode.
The OCR register: Card power up status bit bit (busy) should also
be set to 1 when reset. (busy bit is set to LOW if the card has not
finished the power up routine.)
Signed-off-by: Frank Chang <frank.chang@sifive.com>
Reviewed-by: Jim Shu <jim.shu@sifive.com>
---
hw/sd/sd.c | 14 +++++++++++++-
1 file changed, 13 insertions(+), 1 deletion(-)
diff --git a/hw/sd/sd.c b/hw/sd/sd.c
index bb5dbff68c..9169208dbc 100644
--- a/hw/sd/sd.c
+++ b/hw/sd/sd.c
@@ -294,6 +294,18 @@ static void sd_set_ocr(SDState *sd)
{
/* All voltages OK */
sd->ocr = R_OCR_VDD_VOLTAGE_WIN_HI_MASK;
+
+ if (sd->spi) {
+ /*
+ * We don't need to emulate power up sequence in SPI-mode.
+ * Thus, the card's power up status bit should be set to 1 when reset.
+ * The card's capacity status bit should also be set if SD card size
+ * is larger than 2GB for SDHC support.
+ */
+ sd->ocr = FIELD_DP32(sd->ocr, OCR, CARD_POWER_UP, 1);
+ sd->ocr = FIELD_DP32(sd->ocr, OCR, CARD_CAPACITY,
+ sd->size > SDSC_MAX_CAPACITY);
+ }
}
static void sd_ocr_powerup(void *opaque)
@@ -560,6 +572,7 @@ static void sd_reset(DeviceState *dev)
sd->state = sd_idle_state;
sd->rca = 0x0000;
+ sd->size = size;
sd_set_ocr(sd);
sd_set_scr(sd);
sd_set_cid(sd);
@@ -574,7 +587,6 @@ static void sd_reset(DeviceState *dev)
memset(sd->function_group, 0, sizeof(sd->function_group));
sd->erase_start = INVALID_ADDRESS;
sd->erase_end = INVALID_ADDRESS;
- sd->size = size;
sd->blk_len = 0x200;
sd->pwd_len = 0;
sd->expecting_acmd = false;
--
2.31.1
- [PATCH] hw/sd: Add SDHC support for SD card SPI-mode,
frank . chang <=