[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [PATCH 0/3] Allow to specify the PHY number to use with a specific i
From: |
Peter Maydell |
Subject: |
Re: [PATCH 0/3] Allow to specify the PHY number to use with a specific i.MX FEC/ENET Ethernet device |
Date: |
Fri, 3 Jul 2020 13:31:54 +0100 |
On Sun, 28 Jun 2020 at 21:21, Jean-Christophe Dubois
<jcd@tribudubois.net> wrote:
>
> The PHY device associated to a specific i.MX Ethernet device is not
> necessarily at address 0 on the MDIO bus.
>
> This patch series adds the ability to set the PHY number on the MDIO bus
> for any i.MX6UL based board.
>
> Jean-Christophe Dubois (3):
> Add a phy-num property to the i.MX FEC emulator
> Add the ability to select a different PHY for each i.MX6UL FEC
> interface
> Select MDIO device 2 and 1 as PHY devices for i.MW6UL EVK board.
Applied to target-arm.next, thanks.
-- PMM
[Prev in Thread] |
Current Thread |
[Next in Thread] |
- Re: [PATCH 0/3] Allow to specify the PHY number to use with a specific i.MX FEC/ENET Ethernet device,
Peter Maydell <=