qemu-devel
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [PATCH v2 02/10] ppc: Remove stub of PPC970 HID4 implementation


From: BALATON Zoltan
Subject: Re: [PATCH v2 02/10] ppc: Remove stub of PPC970 HID4 implementation
Date: Tue, 7 Jan 2020 19:05:41 +0100 (CET)
User-agent: Alpine 2.21.99999 (BSF 352 2019-06-22)

On Tue, 7 Jan 2020, Greg Kurz wrote:
On Tue, 7 Jan 2020 18:32:15 +0100
Greg Kurz <address@hidden> wrote:

On Tue,  7 Jan 2020 15:48:19 +1100
David Gibson <address@hidden> wrote:

The PowerPC 970 CPU was a cut-down POWER4, which had hypervisor capability.
However, it can be (and often was) strapped into "Apple mode", where the
hypervisor capabilities were disabled (essentially putting it always in
hypervisor mode).

Isn't it supervisor mode instead of hypervisor mode ?

By the way, do you know if this strapping is hardware or software based? So is it the firmware that disables it on Apple hardware or is it some CPU pin connected somewhere on the motherboard or it's within the CPU and cannot be changed? I wonder if it's theoretically possible to re-enable it on an Apple G5 or we would likely never see a PowerPC 970 with HV enabled?

Regards,
BALATON Zoltan



reply via email to

[Prev in Thread] Current Thread [Next in Thread]