Re: [Qemu-devel] [PATCH v2 2/3] audio: add -audiodev pa, in|out.latency= to documentation

[Gerd Hoffmann]

On Wed, Sep 18, 2019 at 10:53:34AM +0100, Stefan Hajnoczi wrote:
> The "latency" parameter wasn't covered by the documentation.

Doesn't apply cleanly (on top of the surround sound patch series).
Picked the other two into the pull request.
Please rebase & resend once this is merged.

thanks,
  Gerd

> 
> Signed-off-by: Stefan Hajnoczi <address@hidden>
> ---
>  qemu-options.hx | 5 +++++
>  1 file changed, 5 insertions(+)
> 
> diff --git a/qemu-options.hx b/qemu-options.hx
> index a4f9f74f52..6d7fe57dd4 100644
> --- a/qemu-options.hx
> +++ b/qemu-options.hx
> @@ -470,6 +470,7 @@ DEF("audiodev", HAS_ARG, QEMU_OPTION_audiodev,
>      "-audiodev pa,id=id[,prop[=value][,...]]\n"
>      "                server= PulseAudio server address\n"
>      "                in|out.name= source/sink device name\n"
> +    "                in|out.latency= desired latency in microseconds\n"
>  #endif
>  #ifdef CONFIG_AUDIO_SDL
>      "-audiodev sdl,id=id[,prop[=value][,...]]\n"
> @@ -630,6 +631,10 @@ Sets the PulseAudio @var{server} to connect to.
>  @item in|out.name=@var{sink}
>  Use the specified source/sink for recording/playback.
>  
> +@item in|out.latency=@var{usecs}
> +Desired latency in microseconds.  The PulseAudio server will try to honor 
> this
> +value but actual latencies may be lower or higher.
> +
>  @end table
>  
>  @item -audiodev sdl,id=@var{id}[,@var{prop}[=@var{value}][,...]]
> -- 
> 2.21.0
>