Re: [Qemu-devel] [PATCH] migration: Fix postcopy bw for recovery

[Juan Quintela]

Peter Xu <address@hidden> wrote:
> We've got max-postcopy-bandwidth parameter but it's not applied
> correctly after a postcopy recovery so the recovered migration stream
> will still eat the whole net bandwidth.  Fix that up.
>
> Reported-by: Xiaohui Li <address@hidden>
> Signed-off-by: Peter Xu <address@hidden>
> ---
>  migration/migration.c | 3 ++-
>  1 file changed, 2 insertions(+), 1 deletion(-)

Reviewed-by: Juan Quintela <address@hidden>

> diff --git a/migration/migration.c b/migration/migration.c
> index 8b9f2fe30a..b307813aa3 100644
> --- a/migration/migration.c
> +++ b/migration/migration.c
> @@ -3327,7 +3327,8 @@ void migrate_fd_connect(MigrationState *s, Error 
> *error_in)
>  
>      if (resume) {
>          /* This is a resumed migration */
> -        rate_limit = INT64_MAX;
> +        rate_limit = s->parameters.max_postcopy_bandwidth /
> +            XFER_LIMIT_RATIO;
>      } else {
>          /* This is a fresh new migration */
>          rate_limit = s->parameters.max_bandwidth / XFER_LIMIT_RATIO;

I was confused thinking that the two assignations were the same O:-)