RE: [Qemu-devel] RE: boot stops after "booting the kernel, done."

[LiuDejun]

Hi Stephen :

The board config options which I used is :
CONFIG_ARCH_INTEGRATOR=y
CONFIG_CPU_ARM920T=y
CONFIG_ARM_THUMB=y
CONFIG_ARCH_INTEGRATOR_AP=y
--------------------
And the attachment is my kernel config file.

Steven Liu

-----Original Message-----
From: address@hidden [mailto:address@hidden On Behalf Of Stephen M. Webb
Sent: Wednesday, December 24, 2008 2:14 AM
To: address@hidden
Cc: LiuDejun
Subject: Re: [Qemu-devel] RE: boot stops after "booting the kernel, done."

On 23/12/08 04:15, LiuDejun wrote:
>
> After I have compiled the kernel,I used the cmdline belove to start the arm
> kernel:
>
> Qemu-system-arm -kernel zImage -initrd arm_test.img -nographic

The most likely problem is that the kernel you are trying to boot is not 
customized for the particular board you're trying to emulate.  Make sure 
you're choosing the appropriate board by using the "-M" command line switch.

-- 
Stephen M. Webb
Xandros
address@hidden
Tel: +1 613 842 3498 x425
www.xandros.com

---------------------------------------------------------------------------------------------------
Confidentiality Notice: The information contained in this e-mail and any 
accompanying attachment(s) 
is intended only for the use of the intended recipient and may be confidential 
and/or privileged of 
Neusoft Corporation, its subsidiaries and/or its affiliates. If any reader of 
this communication is 
not the intended recipient, unauthorized use, forwarding, printing,  storing, 
disclosure or copying 
is strictly prohibited, and may be unlawful.If you have received this 
communication in error,please 
immediately notify the sender by return e-mail, and delete the original message 
and all copies from 
your system. Thank you. 
---------------------------------------------------------------------------------------------------

.config
Description: Binary data