RE: [Qemu-devel] MS-DOS Network Client

[Andreas Bollhalder]

I use the Novell 16-bit NetWare Client and it works fine with the
TCP/IP stack that GEOS setup on it. FreeDOS EMM386 seems to have some
problem with QEmu. Therefor I use the one from DR-DOS 7.03.

Try the ISA mode with the NE2000 driver set to IRQ = 9 and PORT = 300.
Maybe you could try to patch QEmu with the available PCNET or 3C509
NIC's.

Andreas

> -----Original Message-----
> From: address@hidden 
> [mailto:address@hidden On 
> Behalf Of Andreas Krause
> Sent: Thursday, March 17, 2005 9:11 AM
> To: address@hidden
> Subject: [Qemu-devel] MS-DOS Network Client
> 
> 
> *This message was transferred with a trial version of 
> CommuniGate(tm) Pro*
> Hi there,
> 
> did anyone successfully run Microsoft Network Client in a 
> MS-DOS guest OS?
> 
> Here's my configuration:
> 
> - current qemu-Installer from freeoszoo
> - Host OS: Win XP
> - Guest OS: MS-DOS 6.22 / freedos
> - Network: MS Network Client 3.0
> 
> Running qemu in PCI-mode and trying RTL8029 fails: When 
> loading pcind.dos the driver does not find any network interface
card.
> 
> When running in ISA-mode an using NE2000 the driver 
> ms2000.dos loads but no packet can be received from or send 
> to 10.0.2.2.
> 
> Please, if anyone could tell if it's possible to run 
> preferrably in PCI mode and how to setup networking 
> successfully. My aim is to mount a SMB share (net use x: 
> \\server\share) an run an install.bat from this drive to 
> Install my company's NT4.0-Installation.
> 
> Thanks in advance
> 
> A. Krause
> 
> 
> 
> _______________________________________________
> Qemu-devel mailing list
> address@hidden
> http://lists.nongnu.org/mailman/listinfo/qemu-devel
>