Re: [PATCH] target/arm: Use deposit_z() in BCF opcode

[Peter Maydell]

On Tue, 22 Aug 2023 at 10:51, Philippe Mathieu-Daudé <philmd@linaro.org> wrote:
>
> When clearing a bitfield we don't need to lead the

"load" ?

> source register. Use deposit_z_i32() with the BFC
> opcode to save a load_reg() call.
>
> Signed-off-by: Philippe Mathieu-Daudé <philmd@linaro.org>
> ---
>  target/arm/tcg/translate.c | 9 ++++-----
>  1 file changed, 4 insertions(+), 5 deletions(-)
>
> diff --git a/target/arm/tcg/translate.c b/target/arm/tcg/translate.c
> index b71ac2d0d5..1a6938d1b3 100644
> --- a/target/arm/tcg/translate.c
> +++ b/target/arm/tcg/translate.c
> @@ -7255,7 +7255,7 @@ static bool trans_UBFX(DisasContext *s, arg_UBFX *a)
>  static bool trans_BFCI(DisasContext *s, arg_BFCI *a)
>  {
>      int msb = a->msb, lsb = a->lsb;
> -    TCGv_i32 t_in, t_rd;
> +    TCGv_i32 t_rd;
>      int width;
>
>      if (!ENABLE_ARCH_6T2) {
> @@ -7268,15 +7268,14 @@ static bool trans_BFCI(DisasContext *s, arg_BFCI *a)
>      }
>
>      width = msb + 1 - lsb;
> +    t_rd = load_reg(s, a->rd);
>      if (a->rn == 15) {
>          /* BFC */
> -        t_in = tcg_constant_i32(0);
> +        tcg_gen_deposit_z_i32(t_rd, t_rd, lsb, width);
>      } else {
>          /* BFI */
> -        t_in = load_reg(s, a->rn);
> +        tcg_gen_deposit_i32(t_rd, t_rd, load_reg(s, a->rn), lsb, width);
>      }
> -    t_rd = load_reg(s, a->rd);
> -    tcg_gen_deposit_i32(t_rd, t_rd, t_in, lsb, width);
>      store_reg(s, a->rd, t_rd);
>      return true;

The comment says we are saving a load_reg() call, but the
code change doesn't seem to do that. Before the change:
 * for BFC we call load_reg for rd
 * for BFI we call load_reg for rn and rd

After the change:
 * for BFC we call load_reg for rd
 * for BFI we call load_reg for rn and rd

So we're not saving any load_reg() calls as far as I can see ?

-- PMM