Re: [Qemu-arm] [PATCH v3 00/27] Support disabling TCG on ARM

[Philippe Mathieu-Daudé]

On 7/1/19 5:41 PM, Peter Maydell wrote:
> On Mon, 1 Jul 2019 at 14:25, Philippe Mathieu-Daudé <address@hidden> wrote:
>>
>> Paolo motived me to salvage this (other!) previous series fromi
>> Samuel Ortiz (NEMU project).
>>
>> v1 cover from Samuel [1]:
>>
>>   This patchset allows for building and running ARM targets with TCG
>>   disabled. It splits the target/arm/helper.c file into logical TCG and
>>   non TCG dependent files so that one can build and run QEMU binaries with
>>   or without TCG enabled.
>>
>>   The rationale behind this work comes from the NEMU project where we're
>>   trying to only support x86 and ARM 64-bit architectures, without
>>   including the TCG code base. We can only do so if we can build and run
>>   ARM binaries with TCG disabled.
> 
> I have applied to target-arm.next:
>  1-12
>  14-17
>  19-21
> 
> I had comments about 13 and 18. 22 has a conflict when I try to apply it:
> I think this is just accidental because the functions it's moving are
> next to changes in patch 13 so there's a minor textual conflict, so it
> would be fine with a fixed-up version of patch 13.
> 23-27 are still RFC status so I think best left for the next release.

Thanks a LOT!

I was not expecting this to be merged for this release,
this is very appreciated :)

Regards,

Phil.