[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Qemu-arm] [PATCH 0/4] arm: exynos4: Add dma support for smdkc210
|
From: |
Peter Maydell |
|
Subject: |
Re: [Qemu-arm] [PATCH 0/4] arm: exynos4: Add dma support for smdkc210 |
|
Date: |
Thu, 23 May 2019 13:57:12 +0100 |
On Mon, 20 May 2019 at 22:43, Philippe Mathieu-Daudé <address@hidden> wrote:
>
> Another intent to salvage previous work from Guenter Roeck:
> https://lists.gnu.org/archive/html/qemu-devel/2018-10/msg06302.html
>
> Since v3: https://lists.gnu.org/archive/html/qemu-devel/2018-10/msg06674.html
> - rebased
> - QOM'ify the SoC code
>
> Since v2: https://lists.gnu.org/archive/html/qemu-devel/2018-10/msg06459.html
> - rename init -> create
> - create controllers in SoC rather than the board (Peter Maydell)
> - add Linux dtsi in commit message
>
> Since v1: https://lists.gnu.org/archive/html/qemu-devel/2018-10/msg06335.html
> - Do not factor out pl330_init, which resulted in buggy v1, see:
> https://lists.gnu.org/archive/html/qemu-devel/2018-10/msg06448.html
>
> Guenter Roeck (1):
> hw/arm/exynos4210: Add DMA support for the Exynos4210
>
> Philippe Mathieu-Daudé (3):
> hw/arm/exynos4: Remove unuseful debug code
> hw/arm/exynos4: Use the IEC binary prefix definitions
> hw/arm/exynos4210: QOM'ify the Exynos4210 SoC
Applied to target-arm.next, thanks.
-- PMM