[Qemu-arm] [PATCH v2 01/10] hw/sd/sdhci.c: Remove x-drive property

[Peter Maydell]

The following commits will remove support for the old sdhci-pci
command line syntax using the x-drive property:
 -device sdhci-pci,x-drive=mydrive -drive id=mydrive,[...]
and replace it with an explicit sd device:
 -device sdhci-pci -drive id=mydrive,[...] -device sd,drive=mydrive

(This is OK because x-drive is experimental.)

This commit removes the x-drive property so that old style
command lines will fail with a reasonable error message:
  -device sdhci-pci,x-drive=mydrive: Property '.x-drive' not found

Signed-off-by: Peter Maydell <address@hidden>
Reviewed-by: Alistair Francis <address@hidden>
Reviewed-by: Peter Crosthwaite <address@hidden>
---
 hw/sd/sdhci.c | 6 ------
 1 file changed, 6 deletions(-)

diff --git a/hw/sd/sdhci.c b/hw/sd/sdhci.c
index 7acb4d7..a692eee 100644
--- a/hw/sd/sdhci.c
+++ b/hw/sd/sdhci.c
@@ -1220,12 +1220,6 @@ const VMStateDescription sdhci_vmstate = {
 /* Capabilities registers provide information on supported features of this
  * specific host controller implementation */
 static Property sdhci_pci_properties[] = {
-    /*
-     * We currently fuse controller and card into a single device
-     * model, but we intend to separate them.  For that purpose, the
-     * properties that belong to the card are marked as experimental.
-     */
-    DEFINE_PROP_DRIVE("x-drive", SDHCIState, blk),
     DEFINE_PROP_UINT32("capareg", SDHCIState, capareg,
             SDHC_CAPAB_REG_DEFAULT),
     DEFINE_PROP_UINT32("maxcurr", SDHCIState, maxcurr, 0),
-- 
1.9.1