Re: [Paparazzi-devel] Rolling Spider issues (and quick joystick question)

[Felix Ruess]

Hi Matthew,

I can't really tell you anything about the Rolling Spider (but Freek van Tienen should be able to).

Regarding the error for joystick (input2ivy): you are missing the -ac parameter to specify which aircraft you want to control, see http://wiki.paparazziuav.org/wiki/Input2Ivy#Usage

And yeah, this should be better checked in the code and a proper error printed...

Cheers, Felix

On Sun, Oct 18, 2015 at 8:56 PM, Matthew Samuel Berk <address@hidden> wrote:

In the past couple of days I have been working on implementing Paparazzi on the Rolling Spider.

Initially I was on the fvantienen/rollingspider branch and successfully uploaded the autopilot and was able to connect telemetry via bluetooth. However, you indicated that the fvantienen/rolling_spider branch was more complete and likely would work better. Looking at the code, it does appear more ‘complete’ as it contains more Rolling Spider specific code and modules which is encouraging. Unfortunately, I am not able to get it to compile the Rolling Spider code. The output is as follows (after switching to rolling_spider branch, running

>>

make clean && make

<<

then opening PPZ Center and selecting bebop I get the following output

>>

RUN 'make -C /home/matthew/paparazzinew -f Makefile.ac AIRCRAFT=bebop ap.compile '

make: Entering directory `/home/matthew/paparazzinew'

make: *** No rule to make target `ap.compile'.  Stop.

make: Leaving directory `/home/matthew/paparazzinew'

FAILED 'make -C /home/matthew/paparazzinew -f Makefile.ac AIRCRAFT=bebop ap.compile' with code 2

<<

I have tried comparing diffs between the two branches but was unable to locate anything that stood out as a problem. I’m sure it’s something simple that I just don’t know about, so I was wondering if you had any quick advice. 

Also, I tried using the joystick module after writing an appropriate xml file for my Saitek X52, and get the following error:

>>

RUN '/home/matthew/paparazzinew/sw/ground_segment/joystick/input2ivy  saitekx52.xml'

Fatal error: exception Failure("A/C 'MYAC' not found”)

<<

I am not sure what this error means, and it appears for any joystick I select. I couldn’t find any info on it...

Thanks,

Matthew

_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel