Re: [Paparazzi-devel] Replace Voltage Regulator on Lisa/m.v2

[Zorig Bat]

Oops, I meant the component layout diagram which is not published on the wiki.

Also do you know where I can purchase a replacement voltage regulator for my Lisa/M V2

~Zorig

On Thu, Jul 16, 2015 at 3:48 AM, Felix Ruess <address@hidden> wrote:

For schematics see https://wiki.paparazziuav.org/wiki/Lisa/M_v2.0#Schematic

On Wed, Jul 15, 2015 at 11:31 PM, zorigb <address@hidden> wrote:

I was testing my Lisa/M.V2 board and I accidentally burned it. I was using my
ESC to power the board through one of the servo pins.Everything was fine
until I smelt something burning and the board stopped working even though
the life led(green) is still on. I was shorting the GND and ADC1 pins on the
analog1 port in order to bind a spektrum receiver. I don't exactly know what
went wrong. Afterwards I checked the resistors on the board and some
resistors we're not working anymore. I think the voltage regulator was
damaged somehow and am looking for a way to replace it. Does anyone have
experience replacing the voltage regulator? Also if you have a schematic of
the board can you share it, it would be greatly helpful.

Thank you



--
View this message in context: http://lists.paparazziuav.org/Replace-Voltage-Regulator-on-Lisa-m-v2-tp17185.html
Sent from the paparazzi-devel mailing list archive at Nabble.com.

_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel

_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel