Re: [Paparazzi-devel] DX6i Mixing

[John Voegeli]

After digging into the PPM message my throttle and cmd_thrust is stuck at -2368 
and does not move... however the controller works fine with other aircraft, and 
the monitor shows the throttle working.

-----Original Message-----
From: address@hidden [mailto:address@hidden On Behalf Of John Voegeli
Sent: Saturday, September 27, 2014 5:37 PM
To: Paparazzi UAV devel list
Subject: Re: [Paparazzi-devel] DX6i Mixing

Hi Eric thanks for your reply! I have it in acro not heli, and it was bound to 
the autopilot. I have control of the right stick. It will act like it rolls and 
such you can hear the motors change sounds. Its only the throttle that is 
affected.

-----Original Message-----
From: address@hidden [mailto:address@hidden On Behalf Of Eric Parsonage
Sent: Saturday, September 27, 2014 5:32 PM
To: Paparazzi UAV devel list
Subject: Re: [Paparazzi-devel] DX6i Mixing

HI

It sounds to me like one of two problems.

1) You have the transmitter in hell mode (so the throttle stick is actually the 
pitch stick) this is resolved by changing the transmitter  to fixed wing 
aircraft mode

2) Did you bind the satellite receiver on a spectrum receiver or on a paparazzi 
board? You must bind on a paparazzi board as satelite receivers can be bound in 
several different modes the one that Paparazzi uses is generally not the same 
as low end receivers use. This is resolved by binding the satellite using a 
Paparazzi board.

Regards

Eric







On 28 Sep 2014, at 6:35 am, John Voegeli <address@hidden> wrote:

> I believe I have solved this issue, maybe... But my bigger issue is that even 
> in ATT mode the throttle on my DX6i has no effect on the throttle of the 
> quad. I can arm and disarm by pulling far left or right but the up/down of 
> the throttle does nothing. Ideas?
> 
> -----Original Message-----
> From: address@hidden [mailto:address@hidden On Behalf Of John Voegeli
> Sent: Saturday, September 27, 2014 3:00 PM
> To: Paparazzi UAV devel list
> Subject: [Paparazzi-devel] DX6i Mixing
> 
> Does anyone know a better way.. or at least confirm that I am doing it right, 
> the mixing of the Dx6i... I am able to get the kill switch to work with gear, 
> but the flaps will not control the auto1 or 2. I can only get it to go into 
> ATT mode with no throttle control. Any help will be greatly appreciated.
> 
> Thanks!
> ~JV
> 
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> https://lists.nongnu.org/mailman/listinfo/paparazzi-devel
> 
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> https://lists.nongnu.org/mailman/listinfo/paparazzi-devel


_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel

_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel