Just use the supplied stm32f4_discovery
board file.
It does not have pwm channels yet but you can have look to the
Krooz_sd board file and the you can add at least 9 to the
stm32f4_discovery board file.
Chris
On 08/26/2013 04:41 PM, Luis Carlos wrote:
Hi cris...congratulations..it's possible to post your
configuration file...i have a stm discovery and drotek clone...
The quanton board is a nice board...for porting to paparazzi
relative low cost...stm32f405 processor and fully 10dof sensor
similar to drotek or aspirin...made in germany....it's very nice
for beginners...
Best regards..
http://www.quantec-networks.de/shop/en/quanton/1/quanton-flight-control-rev.-1
http://www.rcgroups.com/forums/showthread.php?t=1833030
Luis Carlos
El 26/08/2013 09:27, "Marius Pfeffer"
<
address@hidden>
escribió:
Hi
The stm32f3 and stm32f4 discovery do not have the
same pinout.
A sensor board that is compatible with both will be
difficoult to draw in eagle and with a huge amount of solder
jumpers.
Just wanted to mention.
sincerely
Marius
_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel
_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel