|
From: | Felix Ruess |
Subject: | Re: [Paparazzi-devel] roll_trim |
Date: | Fri, 23 Aug 2013 09:01:20 +0200 |
There is a small spell error in main_ap.c and main_fbw.c:
=======
* these are passed to fbw via inter_mcu.
*/
>>>>>>> origin/master
I corrected it in my computer and checked the trim values. It takes the trim values from airframe file.
>
>
From: Felix Ruess Subject: Re: [Paparazzi-devel] roll_trim Date: Thu, 22 Aug 2013 14:49:41 +0200 Hi Refik,
Thanks for noticing and reporting this!Seems the trim commands were not properly initialized.The values set in the airframe file were directly written to command_x_trim in fbw, only to be overwritten later from the ap_state->command_x_trim values (which are not explicitly initialzed and hence zero). So when you change the trim commands in settings, only then they are actually applied.
Now the command_x_trim values are initialized in ap_state instead of fbw (and the yaw trim is also set from the airframe file, which was apparently missing before).
Should be fixed in v5.1_devel-148-ga18a74f
Please test and report back.
Thanks, Felix
_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel
[Prev in Thread] | Current Thread | [Next in Thread] |