Re: [Paparazzi-devel] Eagle Tree Airspeed Sensor Problem

[Helge Walle]

Hi,

 

Do you have an alternative device to connect it to for testing?

This would make it easier to determine the source of the fault.

 

I tested mine on an Arduino Duemilanove, which worked fine.

 

Helge.

 

2013/6/14 Eduardo lavratti <address@hidden>

I have this sensor and yapa2 and it work fine.

> From: address@hidden
> Date: Fri, 14 Jun 2013 00:12:34 -0500
> To: address@hidden
> Subject: [Paparazzi-devel] Eagle Tree Airspeed Sensor Problem
>
> Hello all,
>
>
> I am trying to put to work the Eagle Tree airspeed sensor on a YAPA2 connected to the I2C port as described on the wiki. Every time I turn on the autopilot and then power the eagle tree sensor my autopilot freezes (the LEDs on the autopilot board stop blinking), I can see that I only get error packages on the telemetry link and my Ground Station stops receiving information.
>
> I have connected the sensor as described on the wiki (GND to white, +5V to Red, SDA to Yellow and SCL to brown). To power the sensor I connected the Red cable to one of the +5V ports used to power the servos and I also tried connecting it directly to the 14V battery that I am using to power the YAPA2 with the same results.
>
>
> Anyone has any thoughts?
>
> Best Regards,
> Jorge
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> https://lists.nongnu.org/mailman/listinfo/paparazzi-devel
i have the same

_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel