Re: [Paparazzi-devel] Molex PicoBlade

[Stephen Dwyer]

Hello,

You can also get precrimped wires from Mouser I believe:

http://ca.mouser.com/ProductDetail/Molex/79758-0006/?qs=%2fha2pyFaduhazv%252brzlAyvbJ1QRjwdzAoEq4ZtzO%252bURY%3d

Check to make sure it is absolutely correct first. You can get the rest of the PicoBlade line there too.

Thanks,

-Stephen Dwyer

On Mon, Mar 11, 2013 at 3:37 PM, Jake Tarren <address@hidden> wrote:

Awesome, thanks Stuart!

On Mon, Mar 11, 2013 at 3:56 PM, Stuart MacIntosh
<address@hidden> wrote:
> Hello
> Compatible crimpers are on Amazon[1] for USD$60 and Digikey is where I order
> PicoBlade connectors. Hobbyking sell pre-made 3-pin picoblade plugs to
> standard 3 pin servo socket cables.
>
> -Stuart
>
> [1] - http://www.amazon.com/gp/product/B002AVVO7K
>
>
> On 12/03/13 08:46, Jake Tarren wrote:
>>
>> Were just getting started with our Lisa board, and could use some help
>> getting these connectors for cheap, were in the U.S.  Can any of you
>> tell us where we can get these and not have to pay $200USD for the
>> crimpers?  Is there somewhere that pre-crimps wires onto the
>> connectors, and then we solder to that?
>>
>> _______________________________________________
>> Paparazzi-devel mailing list
>> address@hidden
>> https://lists.nongnu.org/mailman/listinfo/paparazzi-devel
>
>
>
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> https://lists.nongnu.org/mailman/listinfo/paparazzi-devel

_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel