Re: [Paparazzi-devel] SSelect SPI

[Felix Ruess]

Hi,
did you enable the gpio slave pin you want to use?
E.g. USE_SPI_SLAVE2

Cheers, Felix

Hi,

Is it still with your Yapa or another board ? Can you send your airframe file and tell us which pins you are looking at ?
Thanks

Gautier

Le 25/02/2013 14:36, Mauro Garcia Acero a écrit :

Dear all,

 

I have a problem with the SSelect port, it doesn't change (from high to low, or otherwise) in any of the options specified:

 

enum SPISlaveSelect {

  SPISelectUnselect, ///< slave is selected before transaction and unselected after

  SPISelect,         ///< slave is selected before transaction but not unselected

  SPIUnselect,       ///< slave is not selected but unselected after transaction

  SPINoSelect        ///< slave is not selected nor unselected

};

 

I have configured the spi_trans struct as follows, using all the possible values in .select and also .slave_idx.

 

            /* configure spi transaction */

            adis_trans.select = SPISelect;

            adis_trans.slave_idx = SPI_SLAVE2;

 

But when a use a monitor on the SPI interface, I don't see any change on CS/SSel signal. What am I doing wrong?

 

Other question, can this value be operational as follows: high when there is no communication, low when a communication begin.

 

Thanks in advance,
Mauro.

_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel

_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel