Re: [Paparazzi-devel] Problems with Serial Communication

On Thu, Oct 18, 2012 at 1:31 AM, Christophe De Wagter <address@hidden> wrote:

It should be easy to connect directly to a computer. Yapa can even connect directly to real rs232 ports. How did you connect? I can not find the attached picture. If you use the Rs232 port that is called UART0. Is R1 mounted? If you use UART1 under the xbee it MUST go to a 3.3v serial port like ftdi cable.
On Oct 18, 2012 12:06 AM, "Jorge Pantoja" <address@hidden> wrote:
Hello everyone,

Has anyone tried to connect the Yapa2 directly to the computer (without the use of Xbees) using the serial port of the computer? We are trying to connect the Yapa2 to the computer through the serial port that is marked on the attached picture.

On the other hand, I think we have configured the "transparent serial" protocol. Basically all we did is the following on the airframe file:
  <firmware name="fixedwing">
     ...
    <subsystem name="telemetry"     type="transparent">
      <configure name="MODEM_BAUD"  value="B57600"/>
      <configure name="MODEM_PORT"  value="UART1"/>
    </subsystem>
  </firmware>
We are not sure if we have configured the "transparent serial" protocol correctly. The problem we are having is that the ground stays black. However, we don't get any errors from the Data Link on the Paparazzi Center.

Best Regards,
--
Jorge Pantoja

Program Manager/Liaison

Phone: +593-989458127

e-mail: address@hidden
_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel
_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel

Jorge Pantoja

Program Manager/Liaison

Phone: +593-989458127

e-mail: address@hidden

From:	Jorge Pantoja
Subject:	Re: [Paparazzi-devel] Problems with Serial Communication
Date:	Thu, 18 Oct 2012 16:10:45 -0500