Re: [Paparazzi-devel] hardware and software development Servo_counter

[Heinrich Warmers]

Hi,
one question for the NAVGO v3,
is it possible to add  2 pins  SERV_RST (pin 48 ) SERV_CLK (pin29) to a 
connector or to make solder pads for it?
Then this nice autopilot is then able to fly normal wing configuration 
or multicopter with low cost motor controller (larger device > 40cm) 
with a separate servo connector  pcb shown in the appendix. This pcb is 
made to solder 2.54 mm connector strips direct for normal servo connectors.

Heinrich


Gautier Hattenberger schrieb:

> Hello Sergey and other hw/sw developers,
>
> When you have developed new hardware (autopilots, expansion boards, 
> sensor boards...) or software (driver, new feature,...), do not 
> hesitate to use this mailing list to announce it, send patches/links, 
> or even better use the github pull request service. And of course, 
> documentation on the wiki is always a good idea ;)
>
> All this OSD discussion shows that people are making a lot of nice 
> stuff around the Paparazzi project and that even more people want to 
> use them! We are really willing to help more developers to share their 
> amazing work and contribute to this project.
>
> If you have any questions on how to contribute, have a look at this 
> page: http://paparazzi.enac.fr/wiki/Contributing or contact us on this 
> mailing list.
>
>
> Happy hacking
>
> Gautier
>
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> https://lists.nongnu.org/mailman/listinfo/paparazzi-devel

hb_servo.pdf
Description: Adobe PDF document

hb_servo_sch.pdf
Description: Adobe PDF document