Thank you Mike,
I have T7CP model and my 3 position switch is switch E (on the upper left corner). But it is very similar, so I will try it.
Regards,
Roman
Von: address@hidden [mailto:address@hidden Im Auftrag von Michael Weigand
Gesendet: Samstag, 16. April 2011 23:00
An: address@hidden
Betreff: Re: [Paparazzi-devel] flight mode
Roman, if its a futaba 7c then you need to edit the radio model settings in the radio. Go to the basic menu, the parameter submenu, select ch5-sw and set it to G which is the 3 pos. Switch on the upper right corner of ur radio. Checkout page 30 of the futaba 7c manual for more details.
Mike
On Apr 16, 2011 9:04 AM, "Roman Nikitin" <address@hidden> wrote:
>
> Hallo everyone,
>
>
>
> as I said before, the problem I had with unexpected mode switching was a weak signal from R/C to receiver. I am trying to use a different R/C, it is FUTABA T7CP 35MHz with an applicable receiver that war proved for the range. The problem is I cannot find the channel to switch the flight modes using the R/C. It has a 3-way-switch but how do I say it should use that one to do the work ?
>
>
>
> I am running out of time.
>
>
>
> I would appreciate if you could give an answer or help me as soon as possible. I am also in IRC channel now.
>
>
>
> Thanks.
>
>
>
> Roman
>
>
>
> Bristol Institute of Technology
>
> University of the West of England
>
> Aerospace Systems Engineering
>
> e-mail: address@hidden
>
> tel. +44 (0) 7760806643
>
> ________________________________________________________
>
> Please consider the environment before printing this email.
>
>
>
>
>
>
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
>