paparazzi-devel
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] PPM wiring


From: Simon Wilks
Subject: Re: [Paparazzi-devel] PPM wiring
Date: Sun, 10 Apr 2011 22:05:00 +0200

Have a look at this: http://www.rcgroups.com/forums/attachment.php?attachmentid=3409599

I connected the +, - and first signal wire to the throttle channel on the receiver (so the receiver has power). The remaining connections require the signal cable only, no need for +/-.

Simon

On Sun, Apr 10, 2011 at 8:02 PM, Roman Nikitin <address@hidden> wrote:

Hi all,

 

I did use ATmega168 PPM encoder before and it seems to be damaged now. So I ordered a newer one that is ATmega328. I am confused a bit, it is not clear how to wire it?! Three wires (+,-, signal) goes to the ap board, for another wires there is one +, one - , and 8 holes for the signals. I found this picture http://paparazzi.enac.fr/wiki/Image:Ppzppmencsetup.jpg  and I am not sure now, how should I do a wiring. In 168 version each of the channels had power, ground and signal  which are going to R/C receiver. Does it mean here that the R/C receiver will be powered just from one wire with one ground wire?! , and for other channels signal wires must be connected only?!

 

Please, I need some help with it. I  have not found any instructions how to do it.

 

It would be nice to have a better picture with some instructions to it.  Just sent it to my private e-mail if you have some or may be a link.

Thank you.

 

Roman

 

Bristol Institute of Technology

University of the West of England

Aerospace Systems Engineering

e-mail: address@hidden

tel. +44 (0) 7760806643

________________________________________________________

 Please consider the environment before printing this email.

 

 


_______________________________________________
Paparazzi-devel mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/paparazzi-devel



reply via email to

[Prev in Thread] Current Thread [Next in Thread]