Re: [Paparazzi-devel] gcs errorlog 1

[Gautier Hattenberger]

smzUAV.xml is probably your airframe file. It should to be in 
conf/airframes. Also, make sure that the path is correct in the 
paparazzi center or directly in the file conf/conf.xml

What is your datalink setup ? (Xbee, FTDI cable,...)


Le 12/12/2010 13:48, Serge Le Huitouze a écrit :
> Arun Sajeevan wrote:
> > Tried the make clean. Ain't showing any difference. Please have a look at
> > the GCS log below. The simulation part is running well. Please tell me if I
> > am doing it correctly : My target is ap, Session :Flight Usb - serial @9600.
> > My green leds have stopped blinking now.Only the reds ones are moving.
> > Any ideas?
> >
> >
> > Run '/home/manikandtan/paparazzi/
> > sw/ground_segment/tmtc/link  -d
> > /dev/ttyUSB0'
> > Run '/home/manikandtan/paparazzi/sw/ground_segment/tmtc/server '
> > Run '/home/manikandtan/paparazzi/sw/ground_segment/cockpit/gcs '
> > Fatal error: exception Failure("File not found:
> > /home/manikandtan/paparazzi/conf/smzUAV.xml")
> > Broadcasting on network 127.255.255.255, port 2010
> > Failure("Pprz.values_of_payload, too many bytes: 02 0c 00 00 73 00 00 01 c5
> > 03 00 00 00 00 ")
> > (...)
> Not familiar enough (yet?) to be able to help you with the networking
> stuff, but your log starts with a "Fatal error" because paparazzi doesn't
> find file "conf/smzUAV.xml".
>
> Please, do fix that first, then come back to the list!
>
> Regards.
>
> --Serge
>
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> http://lists.nongnu.org/mailman/listinfo/paparazzi-devel