|
From: | mark.griffin |
Subject: | RE: [Paparazzi-devel] How to adjust surface travel and throttle? |
Date: | Tue, 17 Aug 2010 11:04:47 +0200 |
Hi Cedric, If you connect a roll gyro to the Funjet, this problem goes away
as the responsiveness of the gyro is very fast. Cheers, Mark From:
address@hidden
[mailto:address@hidden On Behalf
Of Cédric Marzer …and don't launch a funjet in auto1 or auto2 mode. I also
crashed when I tried. The responsivness of the aileron is very low due to the
low speed. I start in manual mode or better : I use a bungee. De :
address@hidden [mailto:address@hidden
De la part de Todd Sandercock You
will be surprised how little movement you will need in auto 1 to keep
the aircraft level. Configure the servo movements in manual mode using the end
point adjustments in the airframe file then try flying the aircraft. Once you
get satisfactory flying control then try auto 1. You
will then need to adjust the pitch and roll gains to near oscillation. If you
don't get enough control in auto 1 after this then I am pretty sure you can
adjust the maximum roll angle to get the desired affect. Just remember that
Auto 1 controls are not the same as you expect from manual control, By pushing
your aileron stick hard one direction it will cause the plane to stay in a
steady bank turn and when you let go the aircraft will self level. Todd From: Edixon
Giraldo <address@hidden> Date: Mon, 16 Aug 2010 17:06:51 +0000 Hi, I have finished my aircraft and now I
need to go to the field and finish tuning. I have a question though about
how to increase or decrease the ailevon travel for the aircraft. Right
now it seems that the ailevons don't move to much when I do the finger on the
sensor test and also do not move symetrically. One seems to move higher
than the other. Also, when I run an AUTO2 test, the throttle seems to
slow to actually have a good take off speed. How do you adjust this
parameters in the airframe.xml code?
_______________________________________________ Paparazzi-devel mailing list address@hidden http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
|
[Prev in Thread] | Current Thread | [Next in Thread] |