RE: [Paparazzi-devel] How to adjust surface travel and throttle?

[Edixon Giraldo]

Sorry, I read through it and I can't figure it out.  It is very vague and does not specify what it needs to be done to increase or decrease the travel of servos or throttle.  I was supposed to do my maiden flight today, but, my funjet crashed taken off.  I took off in AUTO1 and I had very little control of the aircraft because there was not enough travel on the control surfaces.  Back to the building phase again!

---

Date: Mon, 16 Aug 2010 17:06:51 +0000
From: address@hidden
To: address@hidden
Subject: Re: [Paparazzi-devel] How to adjust surface travel and throttle?

Eddie,

Take a look at this page: http://paparazzi.enac.fr/wiki/Airframe_Configuration

It has recently been worked on and should answer a lot of your questions.

Buzz

On 08/16/2010 04:34 PM, Edixon Giraldo wrote:

Hi, I have finished my aircraft and now I need to go to the field and finish tuning.  I have a question though about how to increase or decrease the ailevon travel for the aircraft.  Right now it seems that the ailevons don't move to much when I do the finger on the sensor test and also do not move symetrically.  One seems to move higher than the other.  Also, when I run an AUTO2 test, the throttle seems to slow to actually have a good take off speed.  How do you adjust this parameters in the airframe.xml code?
 
Thanks.
 
Eddie.

_______________________________________________
Paparazzi-devel mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
  

_______________________________________________ Paparazzi-devel mailing list address@hidden http://lists.nongnu.org/mailman/listinfo/paparazzi-devel