paparazzi-devel
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] Electrical connections in the airborne equipment.


From: antoine drouin
Subject: Re: [Paparazzi-devel] Electrical connections in the airborne equipment.
Date: Wed, 14 Jul 2010 15:01:40 +0200

Hey

Awsome schematics, please don't hesitate to upload it on the wiki

Regards

Poine

On Wed, Jul 14, 2010 at 2:17 PM, Helge Walle <address@hidden> wrote:
> Here is a simple sketch showing how I would like to power the onboard
> electronics in a TWOG setup.
>
> The plan is to use these connections for my next plane. On my current
> TwinstarII I use +5V from the TWOG to power the servos. Compared to the
> sketch the difference is that +5V is now taken from the BEC.
>
> There is a jumper on the PPM board for separating the +5V connection, but I
> kept it in place and just left out the +5V lead between the PPM board and
> TWOG.
>
> I use 6-7cm long servo cables between the R/C receiver and PPM board. Do you
> think that the +5V and Gnd in parallell in each servo cable represents a
> problem?
>
> Any comments would be welcome.
>
> Circuit diagram
>
> Best regards,
> Helge.
>
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
>
>



reply via email to

[Prev in Thread] Current Thread [Next in Thread]