paparazzi-devel
[Top][All Lists]
Advanced

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

AW: [Paparazzi-devel] GPS flashing


From: Roman Nikitin
Subject: AW: [Paparazzi-devel] GPS flashing
Date: Fri, 9 Jul 2010 07:42:22 +0100

Felix, 

I don´t have any FTDI cable. So you mean I need to download a tunnel first, and 
then it works through the xbees. Is it correct? And while I am doing this, as I 
can see, the GCS should be running. Or not? Or it is enough if the autopilot is 
powered only and xbees connected?

Thank you.

Roman


 Nachricht-----
Von: address@hidden [mailto:address@hidden Im Auftrag von Felix Ruess
Gesendet: Donnerstag, 8. Juli 2010 22:08
An: address@hidden
Betreff: Re: [Paparazzi-devel] GPS flashing

If you have an FTDI cable you can also just directly connect the GPS,
you don't need to go through the autopilot. But using the tunnel can
be very convenient since you can also just use your already connected
xbees instead of the serial cable.

Felix

2010/7/8 C.KUO <address@hidden>:
> Hi
>
>
>  I assume you use Tiny V2 or TWOG, first you need upload "tunnel" to your
> board though usb (in the paparazzi center, select the new target, and press
> build then upload)
>
>  Then connect your FTDI cable to serial port on the Tiny (where the modem is
> connect to), then you can start us Ublox software to flash your GPS.
>
>
>  I hope these helps
>
>
> Regards
>
>                                                                       Chen
>
>
> 引述 Roman Nikitin <address@hidden>:
>
>> Hi,
>>
>>
>>
>> to flash the GPS, can I use the serial connection or it should be done on
>> the same way I flashed my ap board?
>>
>>
>>
>> Sorry guys, a lot of questions from my side today. I am really in hurry.
>>
>>
>>
>> Thanks.
>>
>>
>>
>> Roman
>>
>>
>>
>>
>>
>> Bristol Institute of Technology
>>
>> University of the West of England
>>
>> Aerospace Systems Engineering
>>
>> email: address@hidden
>>
>> Mob.: +44 (0) 7760806643
>>
>>
>>
>>
>
>
>
> C.KUO
> Aerospace Engineering, MEng
> Mechanical Engineering, PhD
> Research Associate
> Department of Materials Science and Engineering
> Saarland University
> Campus Dudweiler
> Am Markt - Zeile 4
> 66125 Saarbrucken, Germany
> Tel.: +49 (0) 681 - 302 64197
> Fax: +49 (0) 681 - 9302 5934
>
>
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
>

_______________________________________________
Paparazzi-devel mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/paparazzi-devel




reply via email to

[Prev in Thread] Current Thread [Next in Thread]