Re: [Paparazzi-devel] Navilog-modules-for Paparazzi

[antoine drouin]

The runtime setting mechanism (including baudrate change) already
exists in paparazzi

grep for GPS_CONFIGURE in sw/airborne/

Regards

Poine

On Wed, Dec 30, 2009 at 2:59 PM,  <address@hidden> wrote:
> Hello,
>
> we use the 507ETTL. Perfomrance is good.
> There seems to be a problem with the configuration to be saved permanently in 
> the module, but it does not occur after each power cycle. Only if the module 
> is not powered up for some weeks it needs the reprogram.
> I think it will be quite some work to implement the setup in the autopilot 
> code. It needs checks after each step and changes in the baud rate...
> I think it is a problem with the gold cap on the board being too small. 
> Perhaps an exchange with a bigger one could solve the problem.
>
> Are you sure about the 5V power supply. Ours run with 3,3V.
>
> Regards
>
> Marc
>
> -------- Original-Nachricht --------
>> Datum: Wed, 30 Dec 2009 12:32:12 +0100
>> Von: "Prof. Dr.-Ing. Heinrich Warmers" <address@hidden>
>> An: address@hidden
>> Betreff: [Paparazzi-devel] Navilog-modules-for Paparazzi
>
>> Hello,
>> has someone used the Navilog GPS modules for Paparazzi?
>> http://www.navilock.de/produkte/gruppen/13/Boards_und_Module
>> The  NL-507ETTL has a u-blox lea  4 chip set and a ubx protocol  (prize
>> is 35 Euro 30m x30mm 5V )
>> In the mikrokopter forum was a suggestion that the module needs
>> reprogram the parameter after power on or battery power lost.
>> Is it possible to flash the setup string in the lpc2148  memory and send
>> it after cold start?
>> The NL-552ettl ublox has a lea5 chip set but the documentation say that
>> it has only the NEMEA protocol.
>> Regards
>>
>> Heinrich Warmers
>>
>>
>
> --
> Preisknaller: GMX DSL Flatrate für nur 16,99 Euro/mtl.!
> http://portal.gmx.net/de/go/dsl02
>
>
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
>