Re: [Paparazzi-devel] 3 state switch on any R/C controller

[Andrew S]

hello
you can use this pot, but it is not quite useful. especially if you fall...
I use two position switch, and adjust EP for auto1 or auto2.

02.06.09, 06:38, "Michael Caughey" <address@hidden>:

> So if I have a pot on channel 6 could I use that?  Fully one way, middle and 
> fully other way?  for the three modes?  I was hoping that would work but I 
> have not made it that far.
> ----- Original Message ----- 
> From: "Andrew S" <address@hidden>
> To: <address@hidden>
> Sent: Saturday, May 30, 2009 5:25 PM
> Subject: Re: [Paparazzi-devel] 3 state switch on any R/C controller
> what if solder a potentimeter and try to adjust auto1 position?
> 30.05.09, 22:24, "? flying pig" <address@hidden>:
> > Hi there
> >
> > I did that, and the results i get is like on/off only, it is strange.
> >
> > I also try this experiment on the Futaba Skysport 4, some how it gives 3 
> > state, but the neutral react very slow, and when i put it in paparazzi, it 
> > tend to shut of the rc link.
> >
> >
> > Thanks anyway
> >
> >
> >  Chen
> >
> > > From: address@hidden
> > > To: address@hidden
> > > Subject: Re: [Paparazzi-devel] 3 state switch on any R/C controller
> > > Date: Sat, 30 May 2009 21:08:07 +0400
> > >
> > > Hello
> > > try to add two resistor divider between switch inputs. this would give 
> > > central position.
> > >
> > > 30.05.09, 17:04, "? flying pig" <address@hidden>:
> > >
> > > > Hi there
> > > >
> > > > I have recently got one of the remote controll from someone, it is 4 
> > > > channel 40Mhz, the brand is REELY (from Conrad in Germany i believe). 
> > > > I was thinking using for paparazzi.
> > > >
> > > > I have tap in to the R/C receiver, which was ok (just read the chip 
> > > > number without any measurement), however, I have some didfficulty in 
> > > > making 3 state switch.
> > > >
> > > >
> > > > I cut the yaw channel (4th channel), and rewire to 3 state s
> >  witch (on/off/on), however, when i use it, it seen like only have on/off 
> > function.
> > > >
> > > >
> > > > Does anyone has done the similar thing about cutting one channel from 
> > > > the controller to make it into the 3 state switch? can anyone advice?
> > > >
> > > >
> > > >
> > > > Regards
> > > >
> > > > &nbs
> >  p; Chen
> > > > 5 GB ???? ????????????????? ? ???? Windows Live Hotmail
> > > --
> > > Есть ли письма? Знает мобильная Яндекс.Почта 
> > > http://mobile.yandex.ru/online
> > >
> > >
> > > _______________________________________________
> > > Paparazzi-devel mailing list
> > > address@hidden
> > > http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
> > 5 GB ???? ????????o??]???? ? ??? Windows Live Hotmail
> --
> Яндекс.Почта. Чище не бывает http://mail.yandex.ru/nospam
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> http://lists.nongnu.org/mailman/listinfo/paparazzi-devel 
--
Яндекс.Открытки на все случаи жизни http://cards.yandex.ru/