Re: [Paparazzi-devel] Transmitter recommendations

[Alston Pike]

I have a Hitec Laser 6 with the aux gain knob switched out for a 3 
position switch that seems to work pretty well.  It's 72 MHz.

I have the oscillioscope data and a radio conf file made up for it; 
they're just not in cvs.

Alston Pike

Juan Enrique (chichi) wrote:
> You can use futba 2,4ghz in paparazzi ,I do . With the included 
> receiver you can find the ppm stream but ony 5 ch of them 1 to 5 . The 
> 6 and 7 are handled separately and only available with the encoder.
> I use a futaba 6exh 2.4 also with the 4th ch in the radio modified as 
> a 3point switch . Is all I need for the easystar.
>
> Regards.
>
> Juan Enrique
> ----- Original Message ----- From: "John Burt" <address@hidden>
> To: <address@hidden>
> Sent: Tuesday, May 19, 2009 8:14 PM
> Subject: [Paparazzi-devel] Transmitter recommendations
>
>
> > I've used a Futaba T7CAP transmitter for my Paparazzi projects, but 
> > it died recently, so I'm shopping for a replacement. I loved the 
> > T7CAP, but apparently Futaba now only makes this model (and all other 
> > mid-high end models) in 2.4GHz versions. Many of the other 
> > transmitters in paparazzi3\conf\radios are also not sold any longer 
> > due to the rapid switch to 2.4GHz.
> >
> > Are there any 72 MHz transmitters left on the market that have been 
> > tested out to work for Paparazzi systems? Or, do I need to bite the 
> > bullet and purchase a 2.4GHz system, a new receiver (for each of my 
> > various RC aircraft), and a PPM encoder board?
> >
> > John
> >
> >
> >
> > _______________________________________________
> > Paparazzi-devel mailing list
> > address@hidden
> > http://lists.nongnu.org/mailman/listinfo/paparazzi-devel
>
>
>
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> http://lists.nongnu.org/mailman/listinfo/paparazzi-devel